Before Use; Unpacking; Selecting The Proper Nozzle; Assembly - Dirt Devil C-POWER XS Manual De Instrucciones

3 Before use

3.1 Unpacking

3 Before use
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage. Keep the packaging for such an event. However, dispose of
no-longer-needed packaging material properly.

3.2 Selecting the proper nozzle

*
2
1
2
ATTENTION:
Our (mini) turbo brush can only be used to vacuum surfaces that
are not sensitive. Do not clean any floors or objects with the (mini)
turbo brush that you would not clean without a second thought with a
conventional brush. Therefore, do not clean sensitive or polished floor
surfaces with the (mini) turbo brush. Nor should you clean furniture, sen-
sitive carpets, upholstery, covers, or any material with a sensitive texture
with the (mini) turbo brush. If in doubt, refrain from using the (mini) turbo
brush. In every instance, comply with the instructions for care and clean-
ing provided by the respective manufacturer.

3.3 Assembly

A
1
3
A
4
16
*
3
*
6
B
1
B
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1. Select the nozzle according to the surface to be cleaned:
The crevice nozzle and the furniture brush are included as accesso-
4
ries in the scope of delivery besides the floor nozzle (Fig. 2/1).
- Crevice nozzle (Fig. 2/4):
Use this to vacuum dust from hard to reach places.
- Furniture brush (Fig. 2/5):
Use this to vacuum dust off objects that have sensitive surfaces.
Optionally available* (*i.e. included in the scope of delivery depending
on model and features) are also:
- Parquet brush (Fig. 2/2*):
5 Its long bristles make it especially suitable for cleaning delicate sur-
faces (e.g. parquet and laminate floors).
- Turbo brush (Fig. 2/3*):
Is used to vacuum non-sensitive carpets, runners, mats, and the like.
- Mini turbo brush (Fig. 2/6*):
Is used to vacuum non-sensitive upholstery, runners, mats, and the
like.
2. Check the selected nozzle for damage.
ATTENTION:
Use only intact nozzles. If damaged, the nozzle may allow dust to
escape or scratch the surface.
3. Keep the other nozzles inaccessible to children.
WARNING:
Risk of injury! Only attach the nozzles if the appliance is not connected
to the power supply. The cylinder vacuum cleaner could be switched on
by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 3/A1) or handle (Fig. 3/B1).
2. Insert the end of the suction hose into the intake opening (Fig. 4/A) of
C
the vacuum cleaner until you hear and feel it locking into place.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 4/B).
4. Adjust the length of the telescopic tube (Fig. 4/C). Press down the re-
lease latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.