Dry Ironing - Beper 50933H Manual De Instrucciones

Steam iron Use instructions
The light indicator (7) illuminate and when the soleplate is at good temperature switch off.
Pressing the steam switch (4), steam function is activated.
Set the temperature indicator at least on position "•••".
Wait 5 seconds between steam spray and the one other after.
If steam switch (4) is pressed before reaching the setting temperature, steam func-
tion won't work but only water drops; that could stain clothes.
Water drops may result of a non-stop pressure of steam switch (4), by more than 5 se-
conds.
To obtain a non-stop steam, keep steam indicator (3) in position
ATTENTION : always direct the steam to clothes and not in direction of face.
When finished using the iron, unplug the appliance and empty the tank water.
WATER SPRAY
Check that the tank (2) is full of water, direct the spray (1) forward the clothes. Press se-
veral times the water switch (5).
When used for the first time, it is recommended to press several times on water switch (5)
before you obtain the desired spray.
Attention: do not use water spray function on silk.

DRY IRONING

Set the steam indicator (3) on in order to not to use steam function. Set the soleplate
temperature by using the thermostat (8).
The light indicator (7) illuminates and switch off when the soleplate is at good temperature.
Start ironing after iron reached desired temperature.
Please note that the soleplate reached lower temperatures when used without steam.
FILL AND EMPTY THE TANK
This has to be made only when the appliance is unplugged.
Always dry the iron or hands before unplug the appliance after filling the tank.
Make sure the temperature indicator (8) is on "min" and steam indicator (3) is on .Rai-
se the tank lid (2) and slowly fill using a funnel
Do not exceed the maximum limit of the tank.
Do not introduce water into the iron, because of electric shock risks. Close the tank lid (2)
when is full and plug the appliance to the socket.
18