Product Programme; Connection And Operation - Migatronic RALLY MIG 161i Manual De Instrucciones

PRODUCT PROGRAMME

160A welding machine for MIG/MAG and
MMA welding. The machine is air-cooled and
is supplied with built-in wire feed with 2-roll
drive.
Welding hoses and cables
MIGATRONIC's product range can provide
MIG/MAG torches and hoses, return current
cables and wear parts etc.
Accessories
Please contact your Migatronic dealer for
further information on accessories.
Dispose of the product according to
local standards and regulations.
www.migatronic.com/goto/weee

CONNECTION AND OPERATION

Permissible installation
The following sections describe how the machine is made
ready for use and then connected to mains supply, gas supply
etc. The numbers in parentheses refer to the illustrations in this
paragraph.
Mains connection
Before connecting the power source to the mains supply,
ensure that the power source is of the same voltage as the
mains voltage provided and that the fuse in the mains supply is
of the correct size. The mains cable (1) of the power source
must be connected to the correct single phase alternating
current (AC) supply of 50 Hz or 60 Hz and with earth
connection. The power source is switched on with the mains
switch (2).
Configuration
MIGATRONIC disclaims all responsibility for damaged cables
and other damages related to welding with undersized welding
torch and welding cables measured by welding specifications
e.g. in relation to permissible load.
Generator use
This welding machine can be used at all mains supplies
providing sine-shaped current and voltage and not exceeding
the approved voltage tolerances stated in the technical data.
Motorised generators observing the above can be used as
mains supply. Consult your supplier of generator prior to
connecting your welding machine. MIGATRONIC
recommends use of a generator with electronic regulator and
supply of minimum 1.5 x the maximum kVA consumption of
the welding machine. The guarantee does not cover damage
caused by incorrect or poor mains supply.
Connection of shielding gas
The shielding gas hose is fitted to the back panel of the power
source (3) and is connected to a gas supply with a pressure
reduction to max. 8 bar.
Important!
In order to avoid damage to plugs and cables,
good electric contact is required when
connecting the work return cable and welding
torch to the machine.
13