Machine Programme / Initial Operation; Lifting Instructions; Configuration; Important - Migatronic PI 200 DC HP Manual De Instrucciones

MACHINE PROGRAMME
PI 200/250 DC
PI 200 DC is single-phased and PI 250 DC is a
three-phased welding machine for MMA and
TIG welding. Both machines are air-cooled but can be
delivered as water-cooled as special equipment.
Welding hoses
The machine can be equipped with TIG welding
hoses, electrode holders and return current cables
from the MIGATRONIC programme.
Trolley (option)
The machines can be delivered with a transport trolley
with built-in tools tray, torch holder and room for
welding consumables.
Torch cooling unit (option)
A separated torch cooling unit can be delivered which
enables use of watercooled TIG welding torches from
the MIGATRONIC programme.
Moreover, we can offer you the following:

Foot control

INITIAL OPERATION

Mains connection
The machine must be connected to a mains supply
and protection earthing. After the mains plug (1) has
been connected to the mains the machine is ready for
use. Please note that all cable connections must be
made by authorised and qualified staff. Switch on and
off the machine by means of the breaker (3) on the
rear of the machine.

Lifting instructions

The lifting point must be used as
shown in the following drawing. The
machine must not be lifted with a
mounted gas bottle!

Configuration

MIGATRONIC disclaims all responsibility for
damaged cables and other damages related to
welding with undersized welding torches and welding
cables measured by welding specifications e.g. in
relation to permissible load.
Generator use
This welding machine can be used at all mains
supplies providing sine-shaped current and voltage
and not exceeding the approved voltage tolerances
stated in the technical data. Motorised generators
observing the above can be used as mains supply.
Consult your supplier of generator prior to connecting
your welding machine. MIGATRONIC recommends
use of a generator with electronic regulator and
supply of minimum 1.5 x the maximum kVA
consumption of the welding machine. The guarantee
does not cover damage caused by incorrect or poor
mains supply.
Dispose of the product according to local
standards and regulations.
www.migatronic.com/goto/weee

Important!

In order to avoid damage to plugs
and cables, good electric contact is
required when connecting the work
return cable and welding torch to
the machine.
Gas connection
Connect the gas hose (2) to the gas system by means
of a gas pressure reducer with flow control. Fit and
secure the gas hose to the gas connection (6) on the
front of the machine.
16