Remote Control Overview; Using The Picture Quality Adjusting Buttons - Yamaha DPX-530 Manual De Instrucciones

Bottom side
2

◆ Remote control overview

1
2
3
4
5
6
7
8
9

Using the picture quality adjusting buttons

When you press either of the picture quality adjusting buttons, the message for adjusting the picture quality appears. Adjust the picture quality
by pressing the GAMMA and C. TEMP buttons. The picture quality adjustment can be made alternatively in the IMAGE menu (see page 21).
GAMMA............................................................... Selects one of the preset gamma modes.
C. TEMP (COLOR TEMPERATURE) ................ Selects one of the preset color temperatures.
6
1
4
3
16
15
14
13
12
11
10
1. Adjustment foot (Front)
2. Lamp cover
3. Adjustment feet (Rear)
4. Air intake vent
Caution
• Do not replace the lamp immediately after using the
projector because the lamp will be extremely hot and may
cause burns.
1. IR signal transmitter
2. ON ( I ) button
3. DVI button
4. D-SUB button
5. ENTER button
6. MENU button
7. C.TEMP (COLOR TEMPERATURE) button*
8. AUTO button
9. IRIS button
10. GAMMA button*
11. ASPECT button
12. Direction buttons
13. S-VIDEO button
14. COMP. (COMPONENT) button
15. VIDEO button
16. STANDBY ( ) button
* See the below for the picture quality adjusting buttons.
Important
• When you press a button on the remote control, the
buttons on the remote control will light up. Wait
approximately 6 seconds after releasing the button for the
lights to turn off.