Yamaha DPX-1000 Manual De Instrucciones página 15

Basic Operations
I Preparations for projection
Carry out the adjustments necessary to the projection image to
obtain the optimum setting for projection.
STANDBY/ON
ESCAPE
ESCAPE MENU
SETTING
PATTERN SETTING
ASPECT INPUT
LAMP COVER TEMP FAN
<Adjusting the vertical position with V. POS>
The initial setting on this unit is for projection of the image in a
line directly from the center of the lens. Where the center of the
screen is above or below the center of this line, use the V. POS
function to adjust the vertical position of the image up or down.
V. POS can adjust the image up to half the height of the screen.
1.
Press the V. POS button on the remote control or the
SETTING button on the main unit repeatedly to place
the unit in vertical position adjustment (Lens shift)
mode.
2.
Adjust the image to a suitable position by pressing
either the h or g buttons.
3.
Press the V. POS button again or the ESCAPE button
to exit from the vertical position adjustment mode.
<Adjusting image size with ZOOM>
Enlarge or reduce the size of the image to fit the size of the screen.
The maximum extent of this zoom is 1:1.6.
1.
Press the ZOOM button on the remote control or the
SETTING button on the main unit repeatedly to place
the unit in zoom adjustment (Zoom) mode.
2.
Adjust the image to a suitable size by pressing either
the h or g buttons.
3.
Press the ZOOM button again or the ESCAPE button
to exit from the adjustment mode.
12
E-
ZOOM
AUTO
V. POS
V. POS ZOOM FOCUS
IRIS
IRIS SETTING PATT
MENU
ESCAPE
ESCAPE
ASPECT INPUT
<Adjusting focus with FOCUS>
Adjust the focus of the projected image.
1.
Press the PATT button on the remote control or the
PATTERN button on the main unit to display a test
pattern for adjustment.
2.
Press the FOCUS button on the remote control or the
FOCUS
SETTING button on the main unit repeatedly to place
PATT
the unit in focus adjustment mode.
3.
Adjust the unit to an optimal focus setting by
pressing either the h or g buttons.
4.
Press the FOCUS button again or the ESCAPE button
to exit from the focus adjustment (Focus) mode.
<Adjusting the iris diaphragm with IRIS>
This unit is equipped with an IRIS function to switch between the
high levels of black and high contrast images important in a home
theatre and the bright images needed for a large screen. Use this
function as best suits your needs.
1.
Press the IRIS button on the remote control or the
SETTING button on the main unit repeatedly to place
the unit in iris diaphragm adjustment (Iris) mode.
2.
Adjust the unit to an optimal iris setting by pressing
either the + or – buttons.
3.
Press the IRIS button again or the ESCAPE button to
exit from the iris adjustment mode.
<Using the test pattern to perform adjustments>
This unit is equipped with three test patterns: a crosshatch pattern
useful for focus adjustment, and gray scale and color bar patterns
for image adjustment. Use them as best suits your needs.
1.
Press the PATT button on the remote control or the
PATTERN button on the main unit to display a test
pattern for adjustment.
2.
Select a suitable test pattern by pressing either the +
or – buttons.
3.
Press the PATT button again or the PATTERN button
on the main unit to exit from the adjustment mode.