To Cut Holes; To Make A Short Cut; To Stop The Product; To Make A Long Cut - Husqvarna K 7000 Ring Manual Del Usuario

5. Go back to the start of the cut and cut 2-3 cm/
0.79-1.18 in. again, until the full length of the cut has
a depth of 5-10 cm/1.97-3.94 in.
6. Continue to cut to necessary depth.

To cut holes

WARNING: Make sure that large cut pieces
cannot fall on the operator or the product
when you cut.
CAUTION: Cut pieces can fall and cause
damage to the product if the cuts are made
in the incorrect sequence. Always make the
lower horizontal cut before the top horizontal
cut.
1. Attach a support (A) across the area to be cut (B) to
make sure that the cut piece cannot fall.
A
2. Make the lower horizontal cut (C).
D
3. Make the 2 vertical cuts (D).
4. Make the top horizontal cut (E).

To make a long cut

Do this procedure if your cut is more than 1 m/39.4 in.
20
B
E
D
C
1. Attach a long straight object as a support along the
line where the cut is to be made.
2. Cut the full length of the cut to a depth of 50-70
mm/2-3 in. Keep the cutting blade against the
support to make the cut straight.
3. Remove the support.
4. Continue to cut along in the first cut until it has the
sufficient depth.

To make a short cut

Do this procedure if your cut is less than 1 m/39.4 in.
1. Cut the full length of the cut to a depth of 50-70
mm/2-3 in.
2. Continue to cut along in the first cut until it has the
sufficient depth.

To stop the product

WARNING: The cutting blade continues to
rotate for a while after the motor stops. Make
sure that the cutting blade can rotate freely
until it fully stops. If it is necessary to stop
the cutting blade quickly, let the cutting
blade lightly touch a hard surface. Risk of
serious injury.
There are 2 procedures to stop the motor.
• Release the power trigger to stop the motor.
1461 - 001 - 17.02.2020