Maintenance Schedule; To Clean Externally; To Do A General Inspection; To Adjust The Tension Of The Drive Belt - Husqvarna K 7000 Ring Manual Del Usuario

Maintenance schedule

Maintenance
Clean the external parts of the product.
Do a general inspection.
Make sure that the power trigger and the power trigger lockout
operate correctly from a safety point of view.*
Do a check of the cutting blade. Look for cracks and make
sure that the cutting blade is not unusually worn. Replace if it is
necessary.**
Do a check of the drive wheel.
Do a check of the drive belt.
Do a check of the water system.
Do a check of the vibration damping system.*
Do a check of the blade guard.
Do a check of the support rollers and guide rollers
Safety devices on the product on page 9 .
* Refer to
To install the cutting blade on page 12 .
** Refer to

To clean externally

CAUTION: Do not use a high-pressure
washer to clean the product.
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.

To do a general inspection

• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can become damaged.
• Examine the electrical parts for damage. Do not
operate a product that has damaged electrical parts.

To adjust the tension of the drive belt

Tighten a new drive belt after 1 hour of operation.
22
Weekly or each
Daily
X
X
X
X
X
X
X
1. Remove the belt guard.
2. Loosen the screw for the belt tension roller.
Monthly
40 h
X
X
X
1461 - 001 - 17.02.2020