Faults and trouble shooting
The machine will not run
•
Check the power supply and the power cables and make
sure that they are not damaged.
•
Check that the emergency stop button is not pressed by
turning it clockwise.
Machine is hard to hold onto
•
Not enough diamonds under the machine (if grinding thick
glue or soft floors, too few diamonds under the machine
will greatly increase the load on grinder and operator).
Usually also accompanied by high current draw by motor.
Increase number of diamonds under machine to reduce
load on grinder and operator.
Machine is jumping around
•
Rubber shock absorber pads in grinding unit may be worn
out or damaged. Check and change if necessary.
•
Diamonds may not be fitted correctly or have different
heights. Check to ensure all diamonds are fitted correctly
and are the same height.
The machine stops after just a while
•
The machine is overloaded and the overload protection
has been released. Reduce load. The machine will reboot
after about a minute when the engine has cooled off.
The machine stops during start-up
•
The electric motor has been overloaded or a phase is
missing. Allow the machine one or two minues to reset
and try again. When this does not help, contact an
authorised service workshop.
MAINTENANCE
Maintenance
IMPORTANT! Inspection and/or maintenance should be
carried out with the motor switched off and the plug
disconnected.
Used correctly, the machine is an extremely low-maintenance
and reliable product.
Cleaning
Always pull out the plug from the outlet socket before
cleaning, maintenance or assembly.
Always clean all the equipment at the end of the working day.
Do not use a high pressure washer to clean the machine.
In order for the machine to always be cooled sufficiently the
cooling air openings must be kept clear and clean.
Rubber shock absorber pads
Check the rubber shock absorbing pads every month.
Replace if necessary.
Electrical Feed
!
Check that the cord and extension cord are intact and in good
condition.
Never use the machine if the cord is damaged, hand it in to an
authorized service workshop for repair.
Skirt
Make sure that the rubber skirt is intact and clean and that it
seals tightly against the floor. Damaged rubber skirt should
always be replaced.
Service
IMPORTANT! All types of repairs may only be carried out by
authorised repairmen. This is so that the operators are not
exposed to great risks.
WARNING! Never use damaged cables. They
can cause serious, even fatal, personal
injuries.
– 15
English