Assembly; Fit The Handle; Changing The Diamonds; Connect The Vacuum Cleaner - Husqvarna PG 400 Manual De Instrucciones

Fit the handle

• Remove the screws (A).
• Remove the locking knobs (B).
• Fit the handle in the handle stand-off on the machine.
• Refit screws (A) and locking knobs (B).
• The locking knobs should be positioned in-line with the
handlebar to reduce the risk of damaging the knobs when
laying down the machinge when changing tools.

Changing the diamonds

Shut down the machine and disconnect the power plug.
Have a set of gloves ready, as diamond tools can get very hot.
• Crank up the handlebar to the highest position.
• Pull back on handle to lift grinding head off the ground.
8 –
English

ASSEMBLY

• Lay machine back on the ground.
• Put on gloves.
• Use a hammer to remove the diamond segments.
• Affix new diamond segments on the grinding disc.
• Once new diamond segments have been attached,
reverse procedure to lower machine to ground.

Connect the vacuum cleaner

Connect the vacuum cleaner to the machine. Use a 50 mm
(2 inch) hose.
• Use a Husqvarna dust extraction system for complete
dust control.
• Make sure that the filters in the vacuum cleaner are intact
and clean. Pay attention to dust during operation.
• Adjust the rubber skirt to be in contact with the floor to
ensure efficient dust collection.