Hydraulic System; Transport And Storage; Long-Term Storage - Husqvarna FS 3500 G Manual Del Operador

Saws with manual axle adjustment
• The rear axle is adjusted by turning the adjustment bolt
located at the rear lower left of saw frame with an 18mm
wrench.
• If the saw steers to the right while sawing, turn the
adjustment bolt counterclockwise.
• If the saw steers to the left while sawing, turn the
adjustment bolt clockwise.

Hydraulic System

The hydraulic system on this saw is used to raise/lower the
diamond blade and to propel the saw forward or reverse.
The hydraulic system consists of a Hydrostatic Transmission,
a DC Lift Pump with a Flow Control Valve and a Hydraulic Lift
Cylinder.
• The lowering rate of the saw can be adjusted using the
Flow Control Valve. If the saw falls too quickly, turn the
knob on the Flow Control Valve clockwise until an
adequate lowering rate is set.

Transport and storage

• Remove the blade before transportation or storage of the
machine, to avoid damage to the blade.
• Remove all adjustment tools and wrenches
• Close the fuel shut-off valve.
Transport
WARNING! When moving the saw up and
!
down ramps, with engine on, use extreme
caution. For steep ramps, always use a
winch. Never stand below the machine.
Stand only beside.
• To go down a ramp, drive the saw backwards slowly.
• To go up a ramp, drive the saw forward slowly.
20 –
English
OPERATING
Lifting the saw
• Observe care when lifting. You are handling heavy parts,
which imply the risk of pinch injuries or other injuries.
• Always use the machine mounted lifting eye when lifting.
To transport by vehicle
• Secure the equipment during transportation in order to
avoid transport damage and accidents. Use the factory
installed tie down lugs on the saw, front and rear to
prevent movement during transport.
• Do not tow this saw with another vehicle as this may
damage drive components.
Storage
Store the equipment in a lockable area so that it is out of reach
of children and unauthorized persons.
• Stop the engine by turning the Engine start switch to the
STOP position.
• Put Forward/Reverse control lever into the Stop/Neutral
position.
For transport and storage of fuel and battery, see the section
"Fuel handling" and "Battery handling".
For transport and storage of Blades, see the section "Blades".

Long-term storage

Ensure the machine is cleaned and that a complete service is
carried out before long-term storage. Read the engine
owner's manual for additional information on long-term
storage.
• Remove the blade for storage and store it carefully.
• Close the fuel shut-off valve and reinstall the rear
protective cover.
• Grease all nipples before storage.
• Disconnect negative terminal and secure in safe distance
from battery.
• Trickle charge the battery during long-term storage.
• When storing the machine for long periods, the fuel tank
must be emptied. Contact your local gas station to find out
where to dispose of excess fuel.
• Store the machine and its equipment in a dry and frost
proof place.
• If the machine is stored outside, cover the machine.
• Change engine oil after a long-term storage