Husqvarna FS 3500 G Manual Del Operador página 26

Daily Maintenance
WARNING! Switch off the engine before
!
carrying out any checks or maintenance.
Check engine oil level without blade and the saw horizontal for
a flat saw level.
• Check the engine oil level.
• Make sure the level is between the limits.
max
min
Check blade guard for damage
• Check the blade guard for cracks.
• Never use broken or damaged blade guard.
26 –
English
MAINTENANCE AND SERVICE
Check all hoses and clamps for damage or
looseness.
The image only shows some of the hoses and clamps.
• Look for leakage on fuel and hydraulics system. Tighten or
replace as necessary.
Check air cleaner restriction indicator.
• Check and clean the outer air filter if the air cleaner
indicator is red, remove the rear cover by opening the 2 air
filter housing clamps and pulling the housing off.
• Clean the filter by blowing the element from inside out.
Use the lowest possible air pressure to remove the dust
without damaging the element.
Use 42-47 PSI (0,29-0,49 MPa;3,0-5,0 kgf/cm
compressed air to remove particulates.
• Replace any damaged filters or gaskets and check air
hose and clamps for damages or looseness. Tighten or
replace as required.
2
)