Yearly Maintenance - Husqvarna FS 3500 G Manual Del Operador

500 hours service
Replace hydraulic system fluid
• Remove the plug in the inspection opening on the
hydraulic reservoir and use an oil extractor to suck out the
fluid through the inspection opening.
• Refill the reservoir with new oil. Ensure that machine is
level prior refilling.
NOTICE! Do not overfill!

Yearly maintenance

Replace outer and inner air filter
Remove the rear cover by opening the 2 air filter housing
clamps and pulling the housing off. Replace both filters and
refit them in reverse order.
CAUTION! The 2 air filter housing clamps
!
can not be closed unless the outer air filter
is properly installed.
MAINTENANCE AND SERVICE
Lubrication
The image shows all the lubrication points (8 grease nipples).
Clean the nipple. Replace broken or blocked nipples.
• Lubricate the front wheels.
• Lubricate the front axle pivot bearings.
• Lubricate the blade shaft. Two pumps at each end.
• Lubricate hydraulic cylinder pivot pin.
• Lubricate rear axle bearing.
Lubricate blade shaft on top of the base plate.
– 29
English