Handle position
CAUTION! Never use the handlebars to lift the saw.
Use the handlebars to maneuver the saw.
The position of the handlebars can be adjusted in length.
•
Loosen the locking knob A to adjust the length.
•
Set handle B to most comfortable working length. Tighten
the locking knob.
A
B
Moving the machine
Prior to moving the machine, read and understand section
"Starting and stopping".
Moving the machine with the engine off
•
Turn Engine start switch to "RUN" position.
Raise the saw by pressing up the Raise/lower switch on the
Forward/Reverse control lever until the blade (if installed)
clears the pavement surface.
•
Put Forward/Reverse control lever into the Stop/Neutral
position.
•
Pull freewheel lever on control panel.
16 –
English
OPERATING
•
The saw can now be moved by standing behind it and
pushing (while holding the handlebars).
WARNING! Do not attempt to push the saw
!
while it is in neutral position on a grade (or
hill). The saw operator could lose control of
the saw and cause injury to oneself or other
persons in the area.
Moving the saw with the engine on
•
Raise the saw by pressing up the Raise/lower switch on
the Forward/Reverse control lever until the blade (if
installed) clears the pavement surface.
•
Set the Water safety switch to the OFF position.
•
Put the Forward/Reverse control lever into the Stop/
Neutral position. The engine will not start unless the lever
is in the Stop/Neutral position.
•
Pull out the Engine Choke (A).
A