Service Schedule; Daily Maintenance - Husqvarna FS 3500 G Manual Del Operador

Service schedule

The service schedule is based on the machine's operating time. More frequent service intervals might be necessary when working
in dusty or hot environments and in conjunction with work that generates high temperatures. A description of how the operations
are to be performed is to be found in the service review.
For certain service requirements, refer to the service intervals in the service schedule below and keep track on the next service.
The machine will keep track on the working hours and it can be seen in the display.
• Always park the machine on a level surface with the engine OFF and the Engine start switch set in the STOP position before
performing any maintenance. Press the Machine stop on the control panel.
Please read the engine manual for your machine carefully and make sure you understand the instructions before using the
machine. There are some maintenance intervals specified in the engine manual.
In case where same services operation is recommended both in this machine's operator manual and in the engine operator
manual, follow the schedule recommendations given in this manual.

Daily Maintenance

Daily maintenance must also be carried out after transportation.
Check the engine's oil level
Check blade guard for damage
Check hoses and clamps for damage or
looseness. Tighten or replace as required.
Check air cleaner restriction indicator.
Clean outer air filter if indicator is red.
Make sure all safety guards are in place
and in good condition.
Check the water spray over the diamond
blade.
Replace engine oil and filter*
Lubricate front wheels
Lubricate blade shaft (2 pumps each end)
Replace engine oil and filter*
Lubricate front axle pivot bearings
Check wheels for wear or damage.
Check rear wheels for looseness
Check engine air cleaner hose and
clamps
Check hydraulic system fluid level
Lubricate hydraulic cylinder pivot pin.
Lubricate rear axle bearing.
Replace hydraulic system fluid
Replace engine fuel filter (spin-on-type)
Replace outer and inner air filter
* Once at 50h then every 100h
MAINTENANCE AND SERVICE
Daily 50h
X
X
X
X
X
X
X
X
X
100h 250h 500h
X
X
X
X
X
X
X
X
X
X
Yearly
X
– 25
English