Blade Cutting Depth; Straight Line Sawing - Husqvarna FS 3500 G Manual Del Operador

Remove the blade guard
1 Disconnect the water hose from the blade guard.
2 Remove the bolt holding the blade guard.
3 Move the blade guard lock forward until it stops and
unlatches. Lift the blade guard with its handle off the
support spade.
1
2

Blade cutting depth

This saw is equipped with a Blade Depth Indicator which
indicates the depth at which the blade is cutting. This saw also
includes a Blade Depth Stop which stops the cutting depth of
the blade at a specific depth.
For more information about maximum cutting depth for
different blade sizes, see section "Blades"
Use of the Blade Depth Indicator
NOTICE! Only saw as deep as the job specifications require
since deeper sawing can cause structural strength
problems.
• If the engine is running, turn the Engine start switch to the
OFF position to stop the engine.
• Turn the engine start switch to the ON position.
• Lower the saw by pushing the Raise/lower switch on the
Forward/Reverse control lever downwards until the blade
touches the surface to be cut. This will be the reference
point.
OPERATING
•
3
Use of the Blade Depth Stop
•
•

Straight line sawing

While cutting, the blade is creating resistance to driving force
from rear wheels which will cause the machine to yaw in the
same direction as the blade is mounted on. This effect can be
counteracted by adjusting the angle of the rear axle using the
manual axle adjustment.
Rotate the Blade Depth Indicator knob to the zero
position. The blade cutting depth will now be indicated on
the Depth Indicator when the blade is lowered into the
cutting surface.
CAUTION! The touch should be smooth to
!
prevent damaging the blade. Use Saw
lowering speed control knob to slow down
the lowering speed.
Lower the saw by pushing the Raise/Lower switch on the
Forward/Reverse control lever downwards until the blade
is at the required depth ( as indicated on the Blade Depth
Indicator).
Set the Blade Depth Stop by turning the knob clockwise
until tight. Now the maximum cutting depth is set. If the
saw is raised out of the cut surface for any reason it can
now be lowered ti this specific depth by lowering the blade
into the cutting surface with the Raise/Lower switch on the
Speed control lever.
– 19
English