Citrus Press Attachment - Bosch CompactPower MFW35 Serie Instrucciones De Uso

en

Citrus press attachment

X Sequence of figures J
1. Open the cap. Fit the required insert into
the housing.
2. Close the cap until you hear it click into
position.
The shredding attachment is now prepared.
Use
W Risk of injury!
– Do not reach into the feed chute with
your hands.
– Only use the pusher when adding more
food.
Caution!
– The pusher can only be inserted in one
direction.
– Remove hard shells (e.g. on nuts).
– Do not apply great force with the pusher.
Caution! (MFW36.../MFW38...)
– Always use the shredding and cutting
inserts at speed 1 (slow).
– Use the grating insert at speed 2 (fast).
X "Speed setting" see page 21
X Sequence of figures K
1. Fit the prepared attachment onto the
drive of the base unit, holding it at an
angle.
2. Turn the attachment anticlockwise until
you hear it click into position.
3. Fit the filling tray and insert the pusher
in the feed chute.
4. Prepare your food. Chop up large parts
beforehand so they fit into the feed
chute without having to press them in.
5. Place a suitable container under the
attachment. Add the prepared food to
the filling tray.
6. Connect the mains plug. Switch on the
appliance.
Caution! (MFW36.../MFW38...)
After switching on, the appliance runs at
speed 2 (fast). To use the shredding and
cutting inserts, you must press button
+ once to switch to speed 1 (slow).
X "Speed setting" see page 21
7. Use the pusher to slide the food down
the feed chute, applying light pressure.
The food is now cut up or shredded.
24
8. Once you have finished, switch off the
appliance and pull out the mains plug.
9. Remove the filling tray and pusher.
10. Hold down the release button and
turn the attachment clockwise until it
disengages.
11. Remove the attachment, take it apart
and clean all parts. X "Care and daily
cleaning" see page 25
Citrus press attachment
For squeezing juice out of citrus fruits,
e.g. lemons, oranges, grapefruits.
Preparation
W Risk of injury!
The attachment for the citrus press is
directly assembled on the base unit. Do not
insert the mains plug until all preparations
for working with the appliance are complete.
Caution!
The base unit is moved through 90° for
preparation and use of the citrus press
attachment. Never use other attachments in
this position.
X Sequence of figures L
1. Hold the base unit by the carrying
handle and carefully tip up so the
drive points upwards. Possibly turn the
base unit to make the buttons easily
accessible.
2. Insert the driving shaft with the spring
element pointing down in the drive of the
base unit.
Caution!
It should be possible to push the driving
shaft down lightly with your finger. It must
not get sticky with residue from juice or
become blocked with pips or foreign bodies.
3. Fit the collecting tray onto the drive at an
angle.
4. Turn the collecting tray anticlockwise until
you hear it click into position.
5. Fit the filter insert onto the collecting tray.
6. Fit the pressing cone onto the driving
shaft.
The citrus press attachment is now fitted to
the base unit and prepared.