Handle Positions; To Connect A Dust Extractor - Husqvarna PG 690 Propane Manual Del Usuario

11. Attach new diamond tools to the tool plate with a soft
hit of the hammer.
12. Attach the tool plate straight (C) on the grinding disc.
13. Turn the tool plate (D) to the right or to the left to lock
the tool plate to the grinding disc.
14. Carefully lift the product to operation position. Use
the handlebar and the support frame for support.
15. Disengage the support frame.

To connect a dust extractor

WARNING: Do not use the dust extractor if
the dust extractor hose is damaged. The risk
increases that you breathe in dust that is
dangerous to your health. Use approved
respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Make sure that the grinding head is not in operation.
4. Connect the dust extractor hose to the product.
5. Engage the support frame. Refer to
disengage the support frame on page 11 .
14
6. Hang the dust extractor hose on the suspension
7. Disengage the support frame.
C

Handle positions

•
D
•
To engage and
device on the support frame to prevent tension in the
dust extractor hose.
Operation position of the handle:
Transport position of the handle:
1212 - 003 - 25.05.2020