cannot fully prevent injury but it decreases the
degree of injury if an accident does occur. Let your
dealer help you select the right equipment.
•
Always wear approved hearing protection. Long term
exposure to noise can result in permanent hearing
impairment.
•
Always wear protective shoes or protective boots.
Steel toes are recommended. Do not use the
product barefoot.
•
Wear gloves when necessary, for example when you
attach, examine or clean the cutting equipment.
•
Do not wear loose-fitting clothing, jewelry or other
items that can get caught in moving parts.
•
Keep first aid equipment and fire extinguisher close
at hand.
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
•
Do not use a product with defective safety devices.
Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
•
Do not make modifications on safety devices. Do not
use the product if protective plates, protective
covers, safety switches or other protective devices
are not attached or are defective.
To do a check of the ignition lock
•
Start and stop the engine to do a check of the
To start the engine on page 14
ignition lock. See
To stop the engine on page 15 .
and
•
Make sure that the engine starts when you turn the
ignition key to START.
•
Make sure that the engine stops immediately when
you turn the ignition key to STOP.
Safety circuit
The engine can only be started when the conditions are
met as follows:
•
The cutting deck is lifted and the parking brake is
applied.
The engine must stop in the situations that follow:
8
•
The cutting deck is lowered and the operator lifts
from the seat.
•
The cutting deck is lifted, the parking brake is not
applied and the operator lifts from the seat.
To do a check of the safety circuit, try to start the engine
with one of the conditions above not met. Change the
conditions and try again. Do this check daily.
To do a check of the speed limiter
•
Release the forward pedal to brake.
•
For more brake power, press the reverse pedal.
•
Make sure that the forward and reverse pedals are
not blocked and can be operated freely.
•
Make sure that the product brakes when the forward
pedal is released.
Parking brake
WARNING: If the parking brake does not
work, the product can start to move and
cause injury or damage. Make sure that the
parking brake is regularly examined and
adjusted.
To do a check of the parking brake on page 18 .
See
Muffler
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Do not use the product if the muffler is missing or
defective. A defective muffler increases the noise level
and the risk of fire.
Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
CAUTION: The muffler becomes very hot
during and after use and when the engine
operates at idle speed. Be careful near
flammable materials and/or fumes to prevent
fire.
Protective covers
Missing or damaged protective covers increase the risk
of injury on moving parts and hot surfaces. Do a check
of the protective covers before you operate the product.
Make sure that the protective covers are correctly
attached and do not have cracks or other damages.
Replace damaged covers.
To cut grass on slopes
WARNING: Read the warning instructions
that follow before you use the product.
•
To cut grass on slopes increases the risk that you
can not control the product and that it overturns. This
246 - 001 - 04.10.2017