To Use The Product In Non-Collect Mode; To Apply And Release The Parking Brake; To Get A Good Mowing Result; To Stop The Engine - Husqvarna RC 318T Manual De Usuario

To use the product in non-collect mode

1. Start the engine.
2. Make sure that the symbol on the auger control
button is blue. This shows that the product is in non-
Auger control switch with LED
collect mode. See
indicators on page 5 for information on what to do if
the symbols on the auger control switch lights up or
the auger control button is red.
To use the product in collect mode
3. Do steps 4–8 in
on page 16 .
4. When you start to mow, the grass is not collected.

To stop the engine

1. Pull the lift lever for the cutting deck rearward to its
locked position to lift up the cutting deck. The blades
stop to rotate.
2. Turn the ignition key to the STOP position.
18
3. When the product stops, apply the parking brake.

To apply and release the parking brake

1. Press the parking brake pedal down (1).
2. Press and hold the lock button (2).
1
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.

To get a good mowing result

• Do not mow a wet lawn. Wet grass gives inferior
results.
• Start with a high cutting height and lower it gradually.
• Mow with blades that rotate at high speed (highest
permitted engine speed, see
32 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
mowing result also at a higher speed.
• We recommend to use the product in collect mode.
To get the best mowing result in non-collect mode,
cut the grass frequently. To cut the grass frequently
does not take more time. The grass is shorter and
you can mow at a higher speed.
• The product can also be used to collect leaves on
the lawn. Set a high cutting height and set the
product in collect mode.
2
Technical data on page
63 - 007 - 20.06.2017