Unpacking/ Assembly; Starting The Machine - Husqvarna TF545P Manual De Usuario

Note: In the constant desire to improve
the products, the manufacturer states
that the whole of this manual is not
contractual and reserves the right to
modify th especifications
machines without notice.
Unpacking
1• 1
WARNING:
Take care not to cut the
cables or scratch
machine's paintwork when
cutting the edges of the
case.
Ref. Contents of the case
A Engine Parts
B Sub Holder 1st
C Holder Main Comp
D
Lower Tidy Cover
E Drag Bar
F Tine Cover
G Tine Cover Bracket FR.
H Lever Shifting
I Blades
J Wheel
K
Connection Joint
L
Extinsion Cover
M Side Cover
N Locking Handle
O Tine Cover Bracket RR.
P Rubber Cable Holder
Q Connecting Plate
R Hardware Bag Tines only
S Hardware Bag
T Tool Bag
Filling with engine oil
and checking the level
2• 1
Filling with gearbox
2• 2
Topping up the petrol
Recommend to USE
2• 3
Octane Value over 90

UNPACKING/ ASSEMBLY

1• 2
WARNING:
of the
Inappropriate assembly of
this
cause
Ensure that you follow all
the instructions carefully.
Fitting the tine blades.
1 2 3
4 5 6 Illustrations only shows assembly
of the tin blades on the right side.
the
Make sure that sharp edges face
one side on both Right and Left
side tines.
Note: Please pay attention to
distinguish the Sub Holder 1st
and Sub Holder 2nd.
Fitting the connecting joint.
7
8 Fitting the drag bar.
Fitting the handle bar.
9
Adjusting the position of the
10 11
handle bar.
Fitting the clutch control.
12
Turn to proper side and fasten the bolt.
Fitting the lower tidy cover.
13 14
1. Tidy the cables,
2. Put on the rubber holder properly,
3. Put on the cover, and fasten with
bolt.
Fitting the tine cover.
15 16
17 18
Do not tighten the bolt immediately
after installed. Install all 4 bolts and
19
nuts first, then tighten one by one.
Fitting the shifting lever.
20
PTO assemble for accessories.
21

STARTING THE MACHINE

2• 4
oil
2• 5
2• 6
Set the on/off switch to
2• 7
Assembling
rotary tiller could
severe injuries.
Open the fuel tap
Set the choke in
position A
Throttle control
Put the lever to:
ON
WARNING:
After assembling the machine
completely, tighten all the bolts
and screws with the moderation:
do not overtighten.
Note: Any dismantling operation must
only be performed by a Husqvarna
workshop.
Description
of the components
1• 3
1- Engine
2- Tine cover
3- Handle
4- Extension cover
5- Blades
6- Drag bar
7- Upper tidy cover
8- Lever shifting
9- Bumper
1- Clutch control
11- Throttle control
12- Reverse control
13- Side cover
14- Lower tidy cover
Type plate
1• 4
Transport wheel
1• 3
Change the blades with wheels when
transporting
Shifting lever
2• 8
Put the lever to gear N.
Pull the recoil start
2• 9
WARNING:
When the machine
remain within the safety zone.
Set the choke in
2• 10
handle
starts,
position B