Connect Water Line To Fill Valve - KitchenAid KDTM404KBS Manual Del Propietário

11.
Measure cabinet opening
Measure the height of cabinet opening from the underside of the
countertop to the floor where the dishwasher will be installed.
Be sure to measure the lowest point on the underside of the
countertop and the highest point on the floor.
Leveling leg adjustment
Use wrench to initially loosen leveling legs if needed.
Adjust all four leveling legs to the same height by rotating each
foot clockwise or counterclockwise as needed.
The unit comes with the legs set for a 33½" (85.1 cm) height
installation. If your opening height is 34½" (87.6 cm), you would
therefore need to lower all four legs by 1" (2.54 cm).
Legs can be remove if necessary for tight installations.
16

CONNECT WATER LINE TO FILL VALVE

– For Copper line, begin with Step 12
– For Flexible line, begin with Step 14
12.
Copper Water Line
If using copper tubing, measure overall length of copper tubing
required to reach the water supply, cut to length, and attach with
compression fittings.
13.
Slide nut and ferrule onto tubing
(copper tubing only)
Copper tubing only: Put the tubing into the 90° elbow fitting as
far as it will go. (The copper tubing bends and kinks easily.) Push
the nut and ferrule forward and tighten it, so that it sits right up
against elbow threads.
NOTE: To avoid vibration during operation, route the water
supply line so that it does not touch the dishwasher base, frame,
or motor. If using copper tubing, skip step 14 and go to 15.
Nut
Ferrule