Custom Panel Installation (Custom Panel Models Only); Choose Anchor Attachment Method - KitchenAid KDTM404KBS Manual Del Propietário

30.
Move dishwasher all but 6" (15.2 cm)
into cabinet opening
6"
(15.2 cm)
NOTE: Leave unit about 6" (15.2 cm) out from cabinet in order
to install anchor brackets and adjust door tension if needed.
31.
Pull slack from utilities
NOTE: Pull slack out of utilities at the same time the dishwasher
is pushed into the cabinet opening to avoid any kinks.
CUSTOM PANEL INSTALLATION
(CUSTOM PANEL MODELS ONLY)
For custom panel installation, refer to the Custom Panel
Installation Instruction Sheet included in the literature package.
Complete custom panel installation before proceeding to the
"Choose Anchor Attachment Method" section.

CHOOSE ANCHOR ATTACHMENT METHOD

IMPORTANT: The dishwasher must be secured to the cabinet
as one of the final steps. Prepare the dishwasher for this by
attaching the 2 brackets found in the parts bag to the dishwasher.
– For countertops that are wood, laminate or another similar
surface, use Countertop Attachment: go to Step 32.
– For countertops that are marble, granite, or another hard
surface, use Side Attachment: go to Step 33.
NOTE: If the gap between the top of the door and the underside
of the counter top is tight (less than 1/4" [6.35 mm]), we suggest
using Side Attachment to keep from scratching the User Interface
or console with the anchor screws.
Countertop Attachment:
32.
Insert bracket
Tabs must point
to the right.
Remove the brackets from the package, and insert into the open
slots on the left- and right-hand top of the dishwasher collar as
shown. Go to Step 35.
Bend tab
Using pliers, bend/twist tab to lock the brackets in place.
Side Attachment:
33.
Break end of bracket
Break off the end of the bracket along the scored line using
pliers.
Top score
line for
stainless
steel tubs
Bottom
score line
for plastic
tubs
21