Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Other Parts Needed (not provided):
Optional Accessory Parts Available:
Call us at our toll-free number or visit the brand website listed in
the Quick Start Guide for accessory and part information.
3/8" (9.5 mm) Compression x
3/4" (19 mm) Hose Fitting
with rubber seal and 90°
elbow (required to properly
connect household water line
to the dishwasher.)
Household Wiring (Metallic)
Strain Relief to fit 7/8"
(22 mm) hole (required to
properly secure household
wiring to the dishwasher
terminal box.)
NOTE: Use only UL Listed/
CSA Approved parts.
Moisture Barrier Tape
NOTE: Moisture barrier tape
is an optional, added level
of protection if installing a
dishwasher under a wooden
countertop. Recommended
but not required for wooden
countertop.
Side Panel Kit
For enclosing the side of the
dishwasher when installing it
at the end of your cabinetry
(Whirlpool part number varies
with color).
First-Time Installations
Check local codes. Check existing electrical supply. See the
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
Additional Tools Needed:
Small tubing cutter
Cordless drill
Additional Parts Needed (not provided):
NOTE: If using a flexible braided hose, replace inlet hose after
5 years to reduce the risk of hose failure. Record hose installation
or replacement dates on the hose for future reference.
NOTE: Be sure to purchase only Whirlpool factory-certified
parts and accessories for your appliance. Your installation may
require additional parts. To order, refer to the contact information
referenced in your Quick Start Guide.
Wire stripper
1/2" (12.7 mm), 3/4" (19 mm),
and 1
/
" (38 mm)
1
2
hole saw bits
Copper Tubing (3/8" O.D.
suggested) or Flexible
Braided Water Supply Line
Kit. Kit includes braided hose
and 3/8" compression x
3/4" hose fitting.
Screw-Type Clamps 1
1
/
"- 2"
2
(38 mm - 50 mm) (3 maximum)
Optional-Longer Drain Hose
(Maximum length 12 ft (3.7 m)
NOTE: Must meet AHAM/
IAPMO test standards, fit 1"
(25 mm) drain connection,
and be resistant to heat and
detergent.
9
Publicidad
Tabla de contenido
