Cleanup; Operation; On/Off Button - Jacuzzi ESPREE BATHTUB SERIE Instrucciones De Instalación Y Operación

Espree™ Bathtub Series

Cleanup

To avoid dulling and scratching the surface of the bathtub, never use abrasive cleaners. For most soiled surfaces, a
mild liquid detergent and warm water is sufficient. The following is also recommended:
•
Remove spilled plaster with a wood or plastic edge. Spots left by plaster or grout can be removed if lightly rubbed
with detergent on a damp cloth or sponge. Do not use metal scrapers, wire brushes or other metal tools, as they
will damage the bathtub's surface.
•
Paint, tar, or other difficult stains can be removed with Fantastik® or soapy water.
•
Minor scratches which do not penetrate the color finish can be removed by lightly sanding with 600-grit wet/dry
sandpaper. You can restore the glossy finish to the acrylic surface of the bathtub with a special compound,
Meguiar's #10 Mirror Glaze. If that is not available, use automotive rubbing compound followed by an application
of automotive paste wax.
•
Major scratches and gouges which penetrate the acrylic surface will require refinishing. Call Jacuzzi Luxury Bath
to find a service agent in your area.

Operation

All bathtubs manufactured by Jacuzzi Luxury Bath are
designed for "fill and drain," which means the bathtub
should be drained after each use and filled with fresh
water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water
continuously like pools or spas.
Close the drain and fill the bathtub until water is at least
1˝ to 2˝ (25mm to 51mm) above the highest jet (see
water line indicated in the illustration). Do not turn on the
whirlpool system at any time if the jets are not completely
immersed in water. Running the whirlpool system when
there is insufficient water in the bathtub could result
in water spraying outside the bath area. Running the
whirlpool system without water will damage the pump.
When exiting the bathtub, the water level will drop
below the jets which could result in water being
sprayed out of the unit.

ON/Off Button

The ON/OFF button, conveniently located on the bath,
allows you to turn the whirlpool system on and off while in
the bath. Simply push down on the switch button to turn on
the whirlpool system. To turn the system off, push down on
the button again.
Installation and Operation
www.jacuzzi.com
Fill to at least 1˝ to 2˝
above highest jet
Air Control
Knobs (2)
ON/OFF
Button
Overflow
Handle
Jets
Suction Cover
Drain
ON/OFF
Button
Page 15