Delta UniSAW 36-L336 Manual De Instrucciones página 23

ADJUSTING BELT TENSION
1. Open the motor cover.
2. Loosen the bolt (H1) Fig. 54A, and carefully let the
motor rest on the belts.
3. Correct belt tension is indicated with a 1/4" (6.4 mm)
deflection in the center span of the pulleys, using light
finger pressure.
4. When proper tension is achieved, tighten bolt (H1)
Fig. 54A.
NOTE: For instructions on replacing the belts see the
Maintenance section.
BLADE GUARD OPERATION
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
If there is a need to briefly raise the blade guard (for
example, to make a measurement) the guard can be parked
in a raised position. Lift the guard from the front (as shown in
Fig. 54B) and raise guard shield until it snaps into a locked
position above the table. One or both guard shields can be
raised.
When done making the measurement (Figure 54C), return
guard to operating position (Figure 54D).
Keep arms, hands and fingers away from
the blade to prevent serious injury.
To reduce the risk of injury, you must use
the saw blade guard for all through-cuts.
FIG. 54C
23
H1
FIG. 54A
FIG. 54B
FIG. 54D