Installing The Hardware; Mounting The Radio - West Marine VHF650 Manual Del Usuario

Installing the Hardware

Installing the Hardware

Mounting the radio

The.VHF650.can.sit.at.any.angle.in.the.mounting.bracket.so.it.can.easily.
accommodate.the.best.location..First,.determine.the.best.place.to.mount.the.
radio. For optimum performance, find a location that can:
• Properly support the weight of the radio, approximately 2 pounds or
0.9.kilograms..You.may.need.to.use.some.type.of.anchor.with.the.
mounting.screws.to.hold.the.radio,.depending.on.the.surface.
•. Keep.the.battery.leads.as.short.as.possible..
•. Keep.the.antenna.lead-in.wire.as.short.as.possible..
• Allow free air flow around the heat sink on the rear of the radio.
•. Avoid.interference.with.the.ship's.compass.
1. Install.the.radio.into.the.mounting.bracket,.and.connect.the.power
cable.and.accessory cable.
Step 1:
Slide the radio
into the mounting
bracket.
Step 2:
Tighten the mounting knobs
to secure the radio in place.
1
2
E-40