Connecting Accessories; Receiver - West Marine VHF650 Manual Del Usuario

Installing the Hardware

Connecting accessories

Connecting to a GPS receiver
If.you.connect.the.radio.to.a.GPS.receiver,.the.radio.can.automatically.
transmit.your.current.position.during.an.automated.distress.call.or.during.a.
normal.DSC.call.
The.VHF650.supports.a.standard.NMEA0183.input.from.a.GPS.receiver..
Follow.the.steps.below.to.connect.the.VHF650.to.your.GPS.receiver:
13.8V DC
Disconnect.the.accessory cable from.the.accessory.connection.on.the.
1.
radio.
Connect.the.BARE.wire.of.the.included.accessory cable.to.the.
2.
GROUND.WIRE.on.your.GPS.receiver..
Connect.the.GREEN.wire.of.the.included.accessory cable.to.the.
3.
GPS.DATA.OUTPUT.WIRE.on.your.GPS.receiver..Below.is.a.table.of.
common.GPS.receivers.and.the.proper.connections:
Accessory
connector
Accessory
cable
Line up Line up Line up
arrows to
connect
E-44
Orange: NMEA OUT (-)
Black: Ext. Speaker (-)/GND
Green: GPS Data IN (+)
Red: External Speaker (+)
Bare wire: Ground
Brown: PA Speaker (+)
Blue: PA Speaker (-)/ GND
Yellow: NMEA OUT (+)