West Marine VHF650 Manual Del Usuario página 46

Installing the Hardware
Connect.the.BLACK.wire.of.the.included.power cable.to.the.
1.
NEGATIVE.(-).side.of.your.power.source.
Connect.the.RED.wire.of.the.included.power cable.to.the.POSITIVE.
2.
(+).side.of.your.power.source.
Connect.the.power cable.to.the.power connector.on.rear.of.the.
3.
VHF650. (The power connector only fi ts one way.)
NOTE: To extend the life of the radio, use waterproof tape to seal
electrical.connections.
4. Install.your.antenna.according.to.the.manufacturer's.instructions..
5. If.necessary,.consult.the.FCC.guidelines.for.antenna.separation...See.
Antenna.Selection.and.Installation.on.page.67.for.more.details...(In.
summary,.the.FCC.recommends.that.antennas.up.to.3.dB.be.installed.
a.minimum.of.3.feet.from.any.occupied.location;.antennas.over.3.dB.
should.be.installed.at.least.6.feet.away.)
6. Connect.the.PL-259.connector.from.the.antenna.lead-in.wire.to.the.
SO238.connector.labeled.ANTENNA.on.the.back.of.the.VHF650.
Radio connector,
SO238 (female SO238 (female
PL-259)
Antenna lead-in
connector,
male PL-259
E-43