Toto CST646F Manual De Instrucciones Y Del Propietario página 5

5. Install the side screws to the
mounting blocks. Cover the
screw head with the provided
screw caps (ill. 4).
6. Connect the water supply hose (not
provided) to the fill valve (ill. 5).
7. Install the flexible water supply hose to
the angle stop (ill. 5). Make sure that
the hose is free of kinks.
8. Carefully place the lid on top of the
tank, making sure that the full flush push
button is on the left side (ill. 6).
9. If necessary, adjust the length of the push
button rods. They are factory set to the
correct length, so only follow these steps if
applicable to your situation.
INSTALLATION PROCEDURE
ill. 4
Cap
Side-screw
ill. 5
50 mm radius minimum Make sure there are no kinks
ill. 6
Full
Flush
Left
Full ush
5
Cap
Side-screw
Push buttons
Tank lid
Left Right
Partial
Flush
Right
Partial ush
Flush valve