To Examine The Wires; To Examine The Propane/Lpg Tank And Lines; Warranty - Husqvarna S 36 Propane Manual Del Usuario

Part no:
590435901

To examine the wires

Check all wire connections if the product doesn't start.
1. Remove the propane tank.
2. Open the battery hatch.
3. Examine if any connections are loose, damaged or
unconnected.
4. Repair or replace wires as needed.

To examine the propane/LPG tank and lines

CAUTION: All products are equipped with
tamperproof fuel systems. If a fuel problem
exists, contact an authorized service center.
Note: Make sure to weigh the tank as being filled and
never overfill the LPG tank. The LPG tank is designed to
hold a maximum of 20 pounds of propane. The gross
weight of a full tank should not exceed 48 pounds.
Every tank has been pressure and leak tested.
However, every time a tank is filled and/or connected to
the product:

Warranty

All Husqvarna devices and accessories have a 12-
month factory warranty for material and manufacturing
defects. The warranty extends to 36 months when
returning the attached warranty slip. Do not attempt to
repair the suction apparatus without the consent of the
manufacturer.
The warranty does not cover defects which are the
result of normal wear and tear, negligence, defective
use, unauthorised repair or the suction apparatus being
connected to the incorrect voltage.
In the event of any complaint, the suction apparatus or
an agreed part of it must be returned to us or our
authorised representative for warranty examination and
for any warranty repair or replacement.
14
Description
HEPA FILTER T-LINE
WARRANTY
T 8600 Propane
2
1. Make sure the couplers are in line and tightly
screwed together by hand, never complete the
connection of the tank to the machine by using a
tool. If this is not done properly, fuel will not pass
through to the regulator.
2. Carry out a soap test by pressurizing all LPG lines.
3. Spray every inch of line and all connections. If you
find a leak, contact an authorized service center.
When operating the dust extractor:
If the tank has been overfilled, a frost forming
will appear on the LPG lines or on the regulator.
4. Turn off the dust extractor otherwise it will be
damaged.
5. The excess propane in the tank must be ventilated in
a safe manner, see
6. In some cases, the regulator must defrost before
restarting the dust extractor.
S 36 Propane
N/A
SAFETY on page 5 .
518 - 003 - 07.06.2018