Pre-Flash Suppression Or Synchronisation Settings; Servo Mode Partial Light Output Settings - Metz mecablitz 64 AF-1 digital Manual De Instrucciones

10.4.2 Pre-flash suppression or
synchronisation settings
• Press the sensor button
SYNC
M-Servo
display as many times as it takes for the
display for selecting the type of synchroni-
M-
sation.
m
Zoom 35
m
P
1/1
• Press the sensor button on the touch
O
SYNC
display:
synchronisation without pre-flash
The synchronisation of operation is adop-
ted.
LEARN
If the synchronisation set here does not work
properly, then proceed as described in
10.4.4.
SYNC
on the touch
synchronisation with pre-flash
10.4.3 Servo mode partial light output
SYNC
M-Servo
settings
• Press the sensor button
M-
output on the touch display as many times
m
Zoom 35
as it takes for the partial light output
m
display to appear.
P
1/1
O
P
• Press sensor buttons
touch display and set the desired partial
1/8 - 2/3
light output to 1/1, 1/2, 1/8 to 1/256 .
1/16
1/16 - 1/3
• Press the sensor button on the touch
p
q
display for the selected partial light output
1/16
(e.g. 1/16).
SYNC
M-Servo
The partial light output is adopted.
M-
Zoom 35 m
m
Once the slave flash units have achieved
P
flash-readiness, the AF measurement flash
1/16
flashes.
+
Slave groups and remote channels cannot be
set in SERVO mode.
The camera flash unit may not work in the
remote mode.
P
for partial light
on the
k
189