Changing The Key Of The Keyboard (Transpose); Dividing The Keyboard Into Two Instruments (Twin Piano) - Roland RP301R Manual Del Usuario

Performing
Changing the key of the keyboard
( Transpose)
This function allows you to transpose the RP301R's pitch in semi-
tone steps. This transposition also applies to Song playback.
1.
Press the [Transpose] button (it lights).
2.
Hold down the [Transpose] button and press the key
corresponding to the tonic of the desired key.
(In this case, the note will not sound.)
The Transpose setting continues to appear in the display while the
[Transpose] button is held down.
Screen
Trnspose
+1
Memo
You can also adjust this setting by holding down the [Transpose]
button and using the [–] [+] buttons.
Note
While the transpose interval is set to "0", the [Transpose] button
cannot be switched on.
When you release the [Transpose] button, you return to the
previous screen.
3.
To cancel the transposition, press the [Transpose] button
once again.
The [Transpose] button will go out.
Note
With the factory settings, both the song and the keyboard will
be transposed. If you want to transpose only the keyboard or
only the song, make the appropriate setting as described in
"Specifying what the transpose function will aff ect" (p. 24).
Note
The transposition setting is deactivated (the [Transpose]
indicator goes dark) when you select another song.
12
Value Explanation
Positive (+) values raise
-6–0–5
the pitch in semitone
(semitone units)
steps, and negative (-)
values lower the pitch in
(default: +1)
semitone steps.
Example: Playing a Song in the Key of E Major while
using the C-major fi ngering
Hold down the [Transpose] button and press the E key (since E is
the tonic).
Counting from C as a reference point, one moves up four keys,
including the black keys, to reach E, thus "4" appears in the display.
If you play C E G g It will sound E G
Dividing the keyboard into two
instruments ( Twin Piano)
You can divide the keyboard into left and right sections so that two
persons can play the same pitch ranges. This function lets you use
the RP301R as though it were two pianos.
1.
Hold down the [Piano] button and press the [Other]
button so both of them are lit.
Twin Piano will turn on, and the following settings will be applied.
• The keyboard will be divided into left and right sections, with
"middle C" located in the center of each section.
• The left and right sections use the same tone (Grand Piano 1).
• The right pedal (damper pedal) will be the damper pedal for the
right section, and the left pedal (soft pedal) will be the damper
pedal for the left section.
Memo
Twin Piano mode can also be selected via the RP301R's Function
mode (see p. 24).
Canceling Twin Piano
Hold down the [Piano] button and press the [Other] button once
again.
Select a diff erent sound to leave Twin Piano mode.
B
#