Message List - Roland RP301R Manual Del Usuario

Troubleshooting
Symptom
Sound wrong, or are buzzy
& &

Message list

Indication Meaning
Lock
The Panel Lock function is on (p. 13).
Amazing
When playing back a song, this is shown if the song starts on an upbeat.
M:PU
When the Auto Off function is activated, and there is between 30 minutes and 1 minute remaining before the power will be turned off, the remaining time (in
Auto Off
30
minutes) will blink in the display.
USB MIDI
This message appears when you connect the RP301R's USB port to your computer ("ON") or when you disconnect it ("OFF").
ON
Error: 1 You can only read the music file. It can not be saved.
An error occurred during writing. The external media may be corrupted.
Error: 2
Insert other external media and try again. Alternatively, you can initialize the external media.
The external media's protect tab may be in the "Protect" (writing prohibited) position may not yet be initialized.
Error: 10 No external media is inserted. Insert the external media and try again.
There is not sufficient free memory in the save destination.
Error: 11
Either insert other external media or delete unneeded files and try again.
An error occurred during reading. The external media may be corrupted.
Error: 14
Insert other external media and try again. Alternatively, you can initialize the external media.
Error: 15 The file is unreadable. The data format is not compatible with the unit.
Data was not called up in time for playback of the song. After waiting several seconds, you may be able to play back the song by pressing the [
Error: 16
again.
This audio format is not supported.
Error: 18
Please use 44.1 kHz 16-bit linear WAV format audio files.
Error: 30 The memory capacity of the RP301R's internal memory or the connected USB memory is exhausted.
The unit cannot deal with the excessive MIDI data sent from the external MIDI device.
Error: 40
Reduce the amount of MIDI data sent to the unit.
Error: 41 A MIDI cable has been disconnected. Connect it properly and securely.
Error: 43 A MIDI transmission error has occurred. Check the MIDI cable and connected MIDI device.
There may be a problem with the system. Repeat the procedure from the beginning. If it is not solved after you have tried several times, contact the Roland
Error: 51
service center.
The USB flash drive connector was subjected to excessive current. Make sure that there is no problem with the external media, then turn the power off, then on
Error: 65
again.
32
Cause/Action
If you set the volume to the maximum setting, the sound may be distorted depending on how you perform. If this occurs, turn
down the volume.
If you don't hear this in headphones:
Performing at high volumes may cause the speakers or objects near the unit to resonate. Fluorescent lights or glass doors may
also resonate sympathetically. In particular, this is more likely to occur for lower notes and higher volumes. You can take the
following measures to minimize resonances.
• Locate this unit 10–15 cm (4–6 inch) away from walls or other surfaces.
• Keep the volume down.
• Move away from the objects that are resonating.
If you hear this in headphones:
It is likely that there is some other reason. Please contact your dealer or a nearby Roland service center.
Page
—
—
—
] button