RIDGID JP06101 Manual Del Operador página 15

ASSEMBLY
ASSEMBLING JOINTER TABLE TO CABINET
See Figures 15 - 16.
WARNING:
This tool is heavy. To avoid back injury, lift with your
legs, not your back, and get help when needed.
 With help place the bed assembly upside down on two
blocks as shown.
 Place the cabinet on top of the bed assembly as shown.
 Locate the following:
Serrated Hex Head Bolts, 3/8-16 x 3/4 in. ...............3
 Line up the holes in jointer table with the holes in the
cabinet.
 Bolt the jointer table to the cabinet using hex head bolts
and tighten all the bolts. To access third bolt, reach into
dust collection port on left side.
ASSEMBLING SWITCH
See Figure 17.
Switch Key ................................................................1
Screws, 3/16 in. ........................................................2
 Using 3/16 in. screws, mount the switch into place as
shown. Make sure the switch is right side up.
 Install switch key into switch.
4x4s
BED ASSEMBLY
4x4s
HEX HEAD
BOLT
BED ASSEMBLY
4x4s
SCREW
Fig. 1
15
JOINTER CABINET
4x4s
Fig. 16
SWITCH
Fig. 17