Tabla de contenido
Publicidad
Automatic
Buttonhole
(Continued)
Guide slot
® Guide block
(_ Buttonhole guide plate
(_ Buttonhole template
Catch
® Setting mark
_t_Gear
(_ Base plate
_)_ Lever
Select a buttonhole template _). Pull back the guide plate
catch @, and slide the template into the guide plate _
to
get the desired buttonhole. Release the catch to lock the
template into place. Insert the gear(_of
the base plate into
the template guide slot (_l_sothat the guide block ®fits
into
the center of the guide slot.
S
J
_1_ Needle thread
® Bobbin thread
Buttonhole foot
Gear
@ Slot
® Starting point
Attach the buttonhole foot (_. Adjust the position of the
gear(_, so it is aligned with the starting point of the
template®.
The lever can be used to change gear
positions.
Pull the bobbin thread up through the guide slot
of the buttonhole guide plate by turning the handwheel
counterclockwise
while holding the needle thread. Place
the bobbin and needle threads to the left side of the guide
plate. Leave 3" to 4" (7.0 to 10.0 cm) of thread.
J
J
9O
Publicidad
Tabla de contenido
