Sabo 72-12G Manual De Uso página 89

ENG 42
PROBLEM SITUATION
5. Weak engine Key in «ON»,
performance engine running
during cutting
6. The engine Key in «ON»,
stops but the engine running
light flashes
7. The engine Key in «ON»,
stops and the engine running
light goes off
8. The engine Key in «ON»,
stops but the engine running
light stays on
9. Uneven cut Key in «ON»,
and poor grass engine running
collection
LIKELY CAUSE
– forward speed too high in rela-
tion to cutting height
– the safety devices cut in
Electronic card in safety alert, due
to:
– earthed micro-switches
– flat battery
– overload caused by the charge
regulator
– badly connected battery (poor
contact)
– engine badly earthed
– problems in the engine
– cutting deck not parallel to the
ground
– blade cutting badly
– forward speed too high com-
pared to height of grass
– collector channel is obstructed
– cutting deck full of grass
TROUBLESHOOTING
SOLUTIONS
– reduce the forward speed
and/or raise the cutting
deck
– check that the conditions
allowing starting are met
(see page 26/b)
Put the key in the «OFF» posi-
tion and look for the cause of
the problem:
– check connections
– recharge battery
– consult your Dealer
– check battery connections
– check engine earth con-
nection
– consult your Dealer
– check tyre pressures
– re-align the cutting deck to
the ground
– check that the blade is fit-
ted properly
– sharpen or replace the
blade
– check the tension of the
belt
– reduce forward speed
and/or raise the cutting
deck
– wait for grass to dry
– remove the grass-catcher
and empty the collector
channel
– clean the cutting deck