Ryobi TSS121 Manual Del Operador página 22

SQUARING THE BLADE TO THE FENCE
See Figures 20 - 26.
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
 Rotate the control arm until the scale indicator is
positioned at 0°.
 Release the detent release lever, engaging the positive
stop notch, then tighten the miter lock knob to secure
the miter table.
 Loosen bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 20.
SQUARE
SLIDING
MITER
MITER
FENCE
FENCE
TABLE
VIEW OF BLADE SQUARE WITH FENCE
ASSEMBLY
BLADE
MITER
LOCK HANDLE
Fig. 20
22 − English
 If the front or back edge of the saw blade angles away
from the square as shown in figures 21 - 22, adjustments
are needed.
MITER
SLIDING
TABLE
MITER
FENCE
FENCE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
SLIDING
MITER FENCE
FENCE
VIEW OF BLADE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
BLADE
SQUARE
Fig. 21
BLADE
SQUARE
MITER
TABLE
Fig. 22