Safety Fixtures - GOWEIL MS 100 Instrucciones De Servicio

00
Dirt and
objects lying
about

2.6 Safety fixtures

The following safety fixtures have been installed:
Emergency stop button
Pressing the emergency stop button triggers an emergency stop.
Once pressed, the emergency stop button must be released by sliding before the machine can be
switched back on.
06/2011
CAUTION!
Tripping hazard due to dirt and objects lying about!
Contamination and objects lying about are slipping and tripping hazards and may cause
serious injury.
Therefore:
Keep the work area clean at all times.
Remove objects that are no longer needed.
WARNING!
Risk of fatal injuries due to faulty safety fixtures!
Safety is only assured when all safety fixtures function properly.
Therefore:
Before commencing work, check if all safety fixtures have been correctly installed and
function properly.
Never disable any safety fixtures.
Never bypass or alter any safety components.
Make sure that safety fixtures such as emergency stop buttons, emergency trip wires,
etc. are accessible at all times.
NOTICE!
For information on the location of the safety fixtures, see chapter "Design and function."
WARNING!
Risk of fatal injury caused by uncontrolled restart!
Uncontrolled restart may cause serious personal injury or death!
Therefore:
Before turning the machine back on, make sure that the cause that triggered the
emergency stop has been removed and all safety fixtures are installed and
function properly.
Do not release the emergency stop button until there is no more danger.
Safety switch (Emergency Stop)
The safety switch is located at the front on the electric motor.
Knife sharpener MS 100
Safety
9