Connecting To A Power Supply - OHAUS MB35 Manual De Instrucciones

MB35

2.4 Connecting to a Power Supply

Check to ensure the voltage identification label on the Moisture Analyzer matches
your local line voltage.
The halogen dryer unit is designed to operate at a specific line voltage (120 V ac or
240 V ac).
CAUTION:
Connection to line voltages that are above or below the rated voltage can cause
improper operation or damage to the unit.
Allow the Moisture Analyzer to warm up for at least 30 minutes to stabilize when
turned on.
WARNING:
If the power cable supplied is not long enough, use only a proper 3-pin extension
cable with an equipment grounding connector.
Connect power cord as shown. The MB35 is operational when power is
applied. The display remains off until the On/Off button is pressed.
EN-5