Spare Parts; Troubleshooting; Scrap - Erreka VIVO-M203 Manual Del Instalador

4

SPARE PARTS


If the device needs repairing, go to an
authorised assistance centre or manufacturer;
never try to repair it yourself.
5

TROUBLESHOOTING


The F1, F2 and F3 fuses are shown in the diagram of the page 75.
Problem
The gate does not make
any movement when a
key command is given
The gate does not open
(the display shows C4 or
C5)
The gate does not open
(the display shows C9)
The gate cannot
completely close (or
open)
6

SCRAP


The device, up until the end of its useful life,
must be dismounted at its location by an
installer who is as well qualified as the person
who completed the assembly, observing the
same precautions and safety measures. This
will avoid possible accidents and damage to
adjacent facilities.
Cause
Absence of system power supply voltage
F1, F2, F3 or F4 blown
Emergency shutdown button open (the
display shows StOP)
Command devices defective
The transmitter is not programmed in the
control board
The transmitter batteries are flat
The interior or exterior safety device (photocells)
or its cabling is open or defective
Fuses blown
The safety strip or its cabling is open or defective
The safety device detects an obstacle
The operator force is too low (the display
shows F1 or F2)
Run not programmed correctly
MAINTENANCE AND TROUBLESHOOTING

Use only original spare parts.
Solution
Restore the power supply
Replace using another fuse of the
same value and investigate the cause
of the failure
C h e c k t h e p u s h b u t t o n a n d t h e
cabling
Check the respective guides
Programme the transmitter correctly
Replace the batteries
Check the cabling and the device
(photocells)
Replace using another fuse of the
same value and investigate the cause
of the failure
Check the cabling and the safety strip
Remove the obstacle and try again
Correctly programme the operator
force (A6)
Programme again
}
The device must be deposited in the appropriate
containers for subsequent recycling, separating and
classifying of the different materials in line with their
nature. NEVER deposit it in domestic rubbish or in
landfills which are not suitably controlled, as this will
cause environmental contamination.
Control board VIVO-M203(M)
89