Electrical Connections - Erreka VIVO-M203 Manual Del Instalador

4

ELECTRICAL CONNECTIONS


Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, always earthed.

Check the manufacturer's instructions for all the elements installed.
O
These operators REQUIRE capacitors for operation.
O
The operating voltage of the operators and the control board must coincide with the mains voltage
(230VAC-50Hz for the VIVO-M203; 125VAC-60Hz for the VIVO-M203M).
Brake connections

If the operator is fitted with a brake connected internally to the motor (for example, ORION
operators), it is not necessary to connect the brakes, although slowdown should be cancelled
(select CA00).

If the operator is fitted with a brake for independent connection (for example, CICLON or
MAGIC operators), the EPS1 card should be used as shown in this diagram, selecting
parameter Ab01.
FR1
FR2

The EPS1 card can be used for other functions; check the programming table "Advanced
Functions Programming (D1= "A")" on page 85.
M203: 230V/50Hz
COM
F1
L1
L2
DL1: Red LED, FR1 activation
DL2: Green LED, FR2 activation
EPS1
P241Z5
Control board VIVO-M203(M)
INSTALLATION
71