ENAR PH60 Manual De Instrucciones página 27

Release the retaining clips (2) Remove the air filter cover (1). Remove the second
en
third stages of filtration
the second stage filter with a neutral cleaning solution. After drying, apply a mix of gasoline and oil,
and shake it vigorously. Then, lightly squeeze the external primary element (sponge) and mount it on
the third stage, mount the assembly in the filter lower housing, place and close the upper housing
with mounting clips.
5.5.5.
Clean the inside of the fuel tank. Carefully clean every part of the machine, and again make sure all
the bolts and nuts are tightened up as necessary.
5.5.6.
For a prolonged period of storage after a particular job has been terminated, completely drain the
fuel from the interior of the tank, the fuel tube and the carburettor.
Remove the sparking plug, pour a few drops of oil into the cylinder, and by hand get the engine to
make a few revolutions in such a way that the oil reaches the whole area. As for the exterior, clean it
with a cloth dampened with oil.
To store the machine, keep it under cover in a location free from humidity and dust and out of direct
sunlight.
5.5.7.
8
PH60, PH70, PH80
1
3
(4, cartridge). Shake the third stage and blow it from inside to outside. Clean
Monthly maintenance service (every 300 hours):
Correct storage:
Air filter sensor maintenance:
If air filter sensor is present, as air filter dirties, the yellow body in sensor
reaches the red zone indicating need for service. Do filter maintenance as
indicated in point 5.5.4 and reset the sensor by pressing the yellow button.
2
4
(3, sponge) and
TAMPING RAMMERS