Description Of The Unit; Operation; Handling - Daikin Zanotti SB 120-O Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3

Description of the unit

The SB series includes air-cooled or water-cooled (optional) condensing units built on the basis of the single-
block principle. They consist of:
4

Operation

SB single blocks are compression units where cold is produced by vaporizing a liquid refrigerant (HFC type)
at low pressure in a heat exchanger (evaporator). The resulting vapour is brought again into the liquid state by
mechanical compression at a higher pressure, followed by cooling in another heat exchanger (condenser).
The compressor is hermetic, with reciprocating motion, supplied with single-phase or three-phase power.
Defrost takes place automatically in pre-set cycles; manual defrost is also possible.
5

Handling

The unit can be handled by lifting and transport means.
WARNING
Make sure that no one is in transit in the operating area of the lifting/transport means to
prevent any possible accidents to people.
If the unit is in a wooden case or crate, sling the packing properly before handling it.
Lifting speed shall be such as not to make the packed unit oscillate dangerously and
possibly fall.
1. a condensing unit placed outside the cold room;
2. an evaporator placed in an
room;
3. an electric control panel placed on the condensing unit;
4. a wall-mounted remote control panel.
insulated box
and installed outside the cold
20

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido