Indicators And Controls - HumanTechnik signolux alarmo Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
Inserting / replacing the rechargea-
ble batteries (included and already
inserted)
Remove the battery compartment lid:
Push the front plastic cover upwards. A
certain resistance, caused by the lat-
ching, has to be overcome. (Figure 3)
Fig. 3
The plastic cover can now be taken
off, the battery compartment has
become accessible. Observe the cor-
rect polarity when inserting / replacing
the batteries (Figure 4).
Fig. 4
12 English
Attach the plastic cover: Lay the co-
ver onto the housing with approx 1 cm
distance to the lower edge (Figure 5).
Fig. 5
Push the cover downwards until it
clicks back into place. The front cover
is now attached again.

Indicators and controls

Microphone status LED
This LED lights up when the environ-
mental noise reaches a certain level.
Battery status LED
A red battery status LED indicates that
the rechargeable batteries are almost
depleted and must be recharged. Du-
ring recharging, this LED will show an
orange light. A permanent green light
shows that the batteries are charged
and the »alarmo« is active.

Publicidad

Tabla de contenido
loading

Tabla de contenido