Ugolini MINIGEL PLUS 1 Manual De Servicio página 34

PA02 Maximum density in Ice Cream Production Mode: this is the ab-
sorption value of the motor corresponding to the adjustment of the
density to a value of 10.
PA03 Motor rotation speed in Ice Cream Production Mode with an unfi-
nished product.
PA04 Motor rotation speed in Ice Cream Production Mode with a finished
product.
PA05 Motor rotation speed in Conservation Mode.
PA06 Temperature produced in Conservation Mode.
PA07 Lock Keypad.
PA08 Scale representation of temperature.
PA09 Firmware version display circuit board.
2015 version : enabling defrost timer.
PA10 Firmware version power circuit board.
2015 version : counter machine life
4 SUPER SERVICE MODE – ADJUSTING THE MANUFACTORY PARAMETERS
By switching on the dispenser using the master switch and holding down keys A and H simultaneously, the machine can be started
up in Super Service Mode and make adjusting the manufactory parameters. The dispenser will function normally, but it will be pos-
sible to modify the production parameters and any modifications carried out will be stored in the memory for the next time the dispen-
ser is switched on in normal mode.
For information on how to adjust the production parameters, please refer to the instructions for the operation parameters.
Incorrect adjustment of the Production Parameters may compromise the opera-
tion of the machine.
Distributors in more containers from the factory parameters PA11 to PA 27 are
common to all the distributor and therefore can only be adjusted by the control
panel on the right container.
LIST OF PRODUCTION PARAMETERS MINIGEL 1/2/3 (FIRST VERSION)
NAME DESCRIPTION
PA11 Ice Cream Production Mode Density
PA12 Ice Cream Production Mode Density Hysteresis
PA13 Ice Cream Production Mode Temperature Hysteresis
PA14 Compressor lockout time OFF
PA15 Electrovalve lockout time OFF
PA16 Time for which the density must remain above the reference value
PA17 Conservation Mode Temperature Hysteresis
PA18 Maximum motor absorption
PA19 Motor cooling time
PA20 Motor protection intervention delay
PA21 Product conservation alarm temperature
PA22 Tap sensor entry activation
PA23 Temperature probe offset
PA24 Number of motor poles
PA25 Motor control proportional P constant
&
IMPORTANT
IMPORTANT
34
45...90 W
2000...6000 giri/min
2000...6000 giri/min
1000...6000 giri/min
- 5 ÷ + 10 °C
0 / 1 / 2
C / F
Visualisation only
ON / OFF
Visualisation only
Days
ADJUSTMENT INTERVAL
1...10
0...4,0
0...5 °C
0...600 s
0...600 s
0...60 s
0...5 °C
0...100 W
0...600 s
0...60 s
0...10 °C
ON / OFF
?
0...1000
0...1000
75
4000
2000
1000
2 °C
0
C
OFF
0
DEFAULT VALUE
8
0,2
0,5
180
180
1
0,5
90
90
5
4
OFF
0
300
4