OXYHYDROGEN TECHNOLOGIES OXYHTECH MAXI PLUS Manual De Uso página 2

Before the first start-up, remove caps and save them to replace them if it is ever necessary
to send the machine to the factory.
When turning on the machine for the first time (On-Off switch), the screen will indicate the need
to refill the bubbler and the main tank.
In most cases it will only ask you to fill the main tank, since the bubbler usually comes out with
factory water.
The main tank must be filled exclusively with distilled or osmosis water, just like the transparent
external filter. The water from the external filter must be reused to fill the tank when it needs
it, later it will be explained in more detail how to proceed, you will find it in the External filter
level section.
The bubbler must be filled exclusively with tap water. Later, it is explained in more detail how
to proceed, you will find it in the Bubbler level section.
ALWAYS USE THE PROPER FUNNEL. IF CONTAMINATED CONTAINERS OR FUNNELS ARE USED
(REMAINS OF OIL, FAT, DETERGENTS ETC) IT WILL BE ENOUGH REASON TO CONTAMINATE THE
INTERIOR OF THE MACHINE, CREATING A LARGE AMOUNT OF FOAM THAT MAY GENERATE A
TROUBLE. (NOT COVERED BY WARRANTY).
BE VERY CAREFUL NOT TO SPILL LIQUID ON THE TOUCH SCREEN AND ANYWHERE ON THE PANEL.
IF THE WATER OVERFLOWS OR SPLASHES, IT COULD DAMAGE ELECTRONIC PARTS OF THE
MACHINE.
In the back, there is a small container that collects the possible
condensation that may be generated due to the use of the
machine. The collected water can be used to refill the tank.
BACK GAS OUTPUT