Vehicle Preparation - OXYHYDROGEN TECHNOLOGIES OXYHTECH MAXI PLUS Manual De Uso

VEHICLE PREPARATION

If the vehicle has latent errors in the diagnosis, we will erase them as much as
possible.
Before starting cleaning with our machine, any type of motor must be at the
correct working temperature (hot motor between 80º and 90º). The machine
will always indicate through the touch screen the procedure to follow.
PREPARATION AND USE OF THE CARBON CLEANING
MACHINE
1) Connect the jack connector of the automatic starter to the machine (rear) and place
the box on top of the motor.
2) This sensor must be connected to the carbon cleaning machine and to the engine.
Both the machine and the vehicle's engine must be switched off.
It is necessary to place the start sensor fixed with a
flange to some part of the engine (the engine must
still be off) where there will not be an excessive
temperature (for example, above the intake pipe,
filter box, plastic filter protection motor, etc.), as a
rule, on top of plastic elements.
This device records the ignition of the engine, so it will turn the machine on and off
depending on whether the engine is on or off. The sensor has a sticker that indicates
which side the sensor should be supported on (it must be attached to the engine part on
the opposite side of the sticker).
The sensor can be placed either vertically or horizontally.
Securely fix the starter to the motor part with a cable tie.
Horizontal or flat position
Vertical position
3) Fit the tube that injects the oxyhydrogen gas to the engine intake.