2. InStAllAtIon
2.1. FIxeD CIrCuIt BreAker
Fasten the circuit breaker by the side supports - (4x) M12
2.2. DrAW-out CIrCuIt BreAker
Fasten the extraction car from inside - (4x, 6x, 8x) M12;
Pull the rails of both sides as far out as far as possible;
Position the circuit breaker on the rails, paying attention to the perfect fit;
Slowly push the circuit breaker inside the extraction car, until it reaches the end.
(4x) M12
40-50 Nm
Circuit breaker
fitting guide
Rail guide
pin
www.weg.net
Mounting
bolt
ABW - Air Circuit Breaker
19