Safety Instructions; Required Tools; Safety Notices - MSW GD2580-S Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
USER MANUAL
Bedienungsanleitung | User manual | Manuel d´utilisation | Istruzioni per l'uso | Manual de instrucciones
Garage door
G D 2 5 8 0 - S
G D 2 3 7 5 - S
G D 3 0 0 0 - S
G D 2 5 0 0 - I
G D 2 5 8 0
G D 2 3 7 5
G D 2 5 0 0
G D 3 0 0 0
G D 2 3 7 5 - 0
G D 3 0 0 0 - 0
G D 2 5 2 1 - 0
Garage door opener
G D - 8 0 0
G D - 8 0 0 M
G D - 6 0 0 M
E X P O N D O . D E

1. SAFETY INSTRUCTIONS

WARNING – INCORRECT INSTALLATION CAN LEAD TO SEVERE INJURY.
PLEASE FOLLOW ALL INSTALLATION INSTRUCTIONS IN THIS MANUAL:
Keep garage doors properly balanced. Have a professional service person make
repairs to cables, spring assemblies and other hardware, if needed.
Watch a moving door until it completely stops moving. Do not cross the path of
a door in motion, and keep children away from the door. Do not let children play
near a garage door when it is opening or closing.
Never put fingers between the sections of a garage door, and teach children to
keep their hands and fingers clear of section joints, hinges, tracks, springs and
other door parts.
Do not let children play with transmitters or remote controls, and place these
items out of their reach.
Test the automatic reversal monthly. The garage door MUST reverse on contact
with a 40mm high object (or a 50mm by 100mm board laid flat) on the floor. If
the garage door does not reverse, adjust either the force or the limit of distance,
then re-test the automatic reversal. Be careful when making adjustments because
mis-adjustments can cause serious injury or death.
Disconnect the electrical power from the operator before making any repairs or
removing the housing cover.
All the Warning Labels should be placed in a visible location.
Check the functions of the doors on a monthly basis!
Please take good care of this manual after installation in order to have safety
inspection and maintenance regularly according to the manual.
Electric impact drill ϕ10.

2. REQUIRED TOOLS

Electric wrench.
Socket wrench 11mm, 13mm, 14mm.
Band tape.
Screwdriver and cross head screwdriver.
Stepladder.
Hammer.
Pliers.
Saw horses.
Pencil.
Level.

3. SAFETY NOTICES

To ensure your safety and to reduce unnecessary damage, read the following specification
carefully before installation. Only proceed in accordance with the instruction manual.
If you have any questions about any of the procedures, please refer to a qualified
installing engineer or local door dealer.
Rev. 20.11.2017
63

Publicidad

Tabla de contenido
loading

Tabla de contenido